Cut Panel Inspection

Generally, cut panel inspection includes recutting, color shading checking, replacing rejected panels with good and acceptable panels, stain removing etc. After cut board numbering cutting individual will give all slice board to QC. At that point QC controller will check each cut board precisely. In view of layer report or past deformity rate, manager can choose to issue floor by irregular examination or 100% physical assessment to discover imperfection thing. Amid cut board examination, on the off chance that they found any imperfection, ought to write in slice board log book to get substitution texture from the provider by submitting deformity cut board investigation report proportion. Cut panel inspection is done to detect any types of fabric fault if any defective panel found, will be replaced from lay chart wise remnants by following the shade and pattern grain line. QC’s makes cut panel inspection reject percentage report and inform to cutting In-charge.

After placing the serial number in every component of cut panel, inspection process is started from this stage. Though rolls are accepted in initial inspection still there are some defects on the roll. So quality team does sort out those defective components during cut panel inspection. QC replace the defect component from the balance fabrics, which QC kept from each roll, depends on numbering. It is mentionable that QC does record how many layers have completed from each roll to identify the fabric for replacement. The report we are following call “cut panel inspection report”.